[-]
  
  
  
  
[-]
  
[-]
  
  
  
  
[-]
  
  
  
 
 
 
[-]
  
  
  
  
  
  
  
  
  
  
  
  
  
[-]
  
  
[-]
  
  
 
 
 
 
 
[-]
 [+]
 [+]
Updated on 10/10/2018
True Control Center Installation Guide
Distributing the Commence Boot Image
Direct link to topic in this publication:

Distributing the Commence Boot Image

The next part of the process is to distribute the Commence boot image to the relevant PXE distribution points (DPs).

To distribute the Commence boot image:

  1. Start the Configuration Manager Console if it is not already started.
  2. Click the Software Library workspace.

  1. Navigate to Operating Systems | Boot Images

  1. Click to select the Commence boot image.

  1. On the Ribbon, click Distribute Content

  1. On the Review selected content page of the Distribute Content Wizard click Next

  1. On the Specify the content destination page, click Add then select Distribution Point from the dropdown list.

  1. On the Select distribution points that will host this content page, select the checkbox beside the relevant distribution point(s) you wish to distribute the content to then click OK

  1. On the Specify the content destination page, verify that the required distribution points have been added then click Next

  1. On the Confirm the settings page, verify everything is correct then click Next

The progress screen will then be displayed whilst the content is being distributed.

  1. Click Close on The Distribute Content Wizard completed successfully screen.

  1. Refresh the ConfigMgr console and verify under Content Status that the number of distribution points with a status of Success has increased by the number of distribution points the Commence boot image was distributed to.

InformationLeave the ConfigMgr console open as it is required in the next section.  

Now you have distributed your Commence Boot Image, the next stage of the process is to create the Commence Task Sequence.